[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Driving Canon bj10e
- To: bmoffatt@xxxxxxxxxxxxxxxxxx (Bruce Moffatt)
- Subject: Re: Driving Canon bj10e
- From: Ian Holland <ianh@xxxxxxxxxxxxxxxxxxxx>
- Date: Tue, 3 Jan 1995 09:51:35 +1000 (EST)
- Cc: FreeBSD-questions@xxxxxxxxxxxxxxxxxx
- In-reply-to: <199501011059.AA26108@xxxxxxxxxxxxxxxxxx> from "Bruce Moffatt" at Jan 1, 95 09:29:25 pm
- Reply-to: ianh@xxxxxxxxxxxx
- Sender: questions-owner@xxxxxxxxxxx
As Bruce Moffatt enscribed:
>
> Problem:
> I am running freebsd 1.1 on a 486-33. I have a Canon bj10e on lpt0, which
> is giving good output (now that I have switched dip switch 6 to add auto
> CR to LF), but the printer runs so slowly its not a workable solution.
<snip>
> I will be upgrading to FreeBSD 2.? as soon as I am comfortable I can tame
> the beast (hopefully 2.1 will install easier than 2.0)
> Any help on printer problem gratefully accepted. :)
I used to have this same setup (except it was a 386-33), and know what
you mean. The solution I found (and you probably aren't going to like
this) was to upgrade to 1.1.5 - even the ghostscript output appeared
to scream on through.
So, I guess, if you can hold on until you go to 2.0, you won't
have the problem any longer.
--
Ian Holland
Mincom Pty Ltd
ianh@xxxxxxxxxxxx
